Available on Request
Straight Micro Steel Fiber
Short, straight steel fibers for UHPC, HPC and dense specialty cementitious matrices where dispersion, fiber volume, finish and matrix compatibility are central.
Material and geometry
High fiber count in a dense matrix
Straight micro steel fiber uses short, fine geometry rather than hooked-end anchorage. Crack bridging depends on bond, embedment, fiber orientation and the high-performance cementitious matrix.
Mixing and dispersion
Production method is part of the product decision
Build the matrix
Confirm powders, aggregate size, water-binder ratio and admixtures.
Set consistency
Establish target rheology before high fiber addition.
Introduce gradually
Use the verified addition sequence and sufficient mixer energy.
Inspect dispersion
Check clumping, orientation, flow, casting and surface finish.
When it is considered
Fine crack bridging and high-performance matrices
Straight micro steel is commonly evaluated for thin UHPC components, overlays, precast architectural or infrastructure elements and other systems designed around high compressive strength and tensile behavior.
- UHPC/HPC mix qualification
- Thin-section or complex mold filling
- Surface finish and exposed fibers
- Fiber orientation in flowable mixes
- Mixing capacity and cycle time
- Mechanical test and acceptance plan
Discuss a straight micro steel requirement
Send the mix system, component geometry, target performance, fiber dimensions if specified, quantity and destination.